Fleck manual control valve

4 • FLECK Downflow Service Manual INSTALLATION CONTINUED By-Pass Valves Always provide for the installation of a by-pass valve if unit is not equipped with one. CAUTION Water pressure is not to exceed psi ( bar), water temperature is not to exceed °F (43°C), and the unit cannot be subjected to freezing conditions.  · Fleck water softener control valve manual drain line is securely in place before the use of the water softener system. When the system regenerates, there will be increased flow via this tubing, which may cause the tubing to become loose. Programming the Fleck Meter Valve: • Before start-up a few simple steps must be [ ].  · Fleck water softener control valve manual Trouble-Shooting Fleck Model Econominder water softener A device or Support after the sale Fleck control valve with meter based as simple as turning a valve. Service Manual The fleck valves offer ease of operation and long lasting trouble free operation.

Page 5 Valve Installation and Start-up Procedures 1. Place the softener tank where you want to install the unit. NOTE: Be sure the tank is level and on a firm base. 2. During cold weather it is recommended that the installer warm the valve to room temperature before operating. Model // 7 Cycle timer into backwash position. Turn manual knob so that the micro switch rides on the first set of pins. — In this position the tanks switch (lower piston) and the control valve moves to the backwash position (upper. • The information, specifications and illustrations in this manual are based on the latest information available at the time of printing. The manufacturer reserves the right to make changes at any time without notice. • This manual is intended as a guide for service of the valve only. System installation requires information from a number of.

4 • FLECK Downflow Service Manual INSTALLATION CONTINUED By-Pass Valves Always provide for the installation of a by-pass valve if unit is not equipped with one. CAUTION Water pressure is not to exceed psi ( bar), water temperature is not to exceed °F (43°C), and the unit cannot be subjected to freezing conditions. Fleck Control Valves (Water Softener Backwash) The reliable Fleck 56Twin Demand control valves for back-washable filters and softeners can handle flow rates up to 20 gallons per minute and are made to provide the backwash capacity for softeners up to 12" in diameter and filters up to a 10" diameter. regeneration steps are complete the valve returns to service and resumes normal operation. Pressing the Extra Cycle button during a regeneration cycle immediately advances the valve to the next cycle step position and resumes normal step timing. Control Operation During Programming The control only enters the Program Mode with the valve in service.